10 hours of testing- high heat output for a truck tent. The remote that comes with the unit is only a fuel pump regulator. The actual thermostat is located in the control modual connected to the unit. It's only 3 wire so it'll be extended into the tent. Using 3" dryer vent as duct, but be careful on the length as it will cause overheat if it's too long. Make sure to burn the heater for at least 5 hours to kill the smell from the heat exchanger and plastics. Also don't switch the heat from high straight to low, it leaves too much fuel in the burner and causes heavy exhaust. Slowly turn it down so it won't build up suit. The unit takes a few minutes to warm up but it'll quiet down as it gets up to temperature. Worth every penny for what it does.